Maintenance of air compressor in laser cutting machine
The air compressor is a part of the laser cutting machine system. First, let's talk about its concept. The air compressor is the main body of the gas source device. It is a device that converts the mechanical energy of the prime mover (usually motor) to the gas pressure energy, and it is the pressure generating device of the compressed air. The following is the maintenance of its main components.
1.filter core of air filter. In general, remove dust impurities on the surface of the filter core every 500 hours and check if they need to be replaced every 2000 hours. The inspection or replacement period may be extended or shortened according to the dust content.
2. Air intake valve seal. In the air compressor of the laser cutting machine, the condition of the sealing ring should be checked for 4000 hours every work, and the replacement should be made when necessary.
3, compressor lubricating oil. Check whether the lubricating oil is sufficient every 1000 hours and replace the new oil every 4000 hours.
4, oil filter. A new piece should be replaced every 2000 hours.
5. Oil vapor separator. You need to replace a new piece every 4000 hours.
6. Minimum pressure valve. Clean it every 4000 hours and check if the pressure is normal.
7. Safety valve. Check its movements every 4000 hours.
8. The oil discharge valve. Water and dirt are discharged every 2000 hours.
9. Drive belt. Adjust the tightness every 2000 hours, check the wear and tear every 4000 hours, and decide whether to change according to the wear condition.
10. Motor maintenance. Maintenance according to the operation instructions of the motor.
In order to make the air compressor of the laser cutting machine run normally and reliably and ensure the service life of the unit, detailed maintenance plan must be worked out, including scheduled operation, regular maintenance, regular inspection and maintenance, so that the air compressor unit is clean, oil-free and dirt free.
The GEM Laser is a system designed for the purple day. Welcome to our website.
1.filter core of air filter. In general, remove dust impurities on the surface of the filter core every 500 hours and check if they need to be replaced every 2000 hours. The inspection or replacement period may be extended or shortened according to the dust content.
2. Air intake valve seal. In the air compressor of the laser cutting machine, the condition of the sealing ring should be checked for 4000 hours every work, and the replacement should be made when necessary.
3, compressor lubricating oil. Check whether the lubricating oil is sufficient every 1000 hours and replace the new oil every 4000 hours.
4, oil filter. A new piece should be replaced every 2000 hours.
5. Oil vapor separator. You need to replace a new piece every 4000 hours.
6. Minimum pressure valve. Clean it every 4000 hours and check if the pressure is normal.
7. Safety valve. Check its movements every 4000 hours.
8. The oil discharge valve. Water and dirt are discharged every 2000 hours.
9. Drive belt. Adjust the tightness every 2000 hours, check the wear and tear every 4000 hours, and decide whether to change according to the wear condition.
10. Motor maintenance. Maintenance according to the operation instructions of the motor.
In order to make the air compressor of the laser cutting machine run normally and reliably and ensure the service life of the unit, detailed maintenance plan must be worked out, including scheduled operation, regular maintenance, regular inspection and maintenance, so that the air compressor unit is clean, oil-free and dirt free.
The GEM Laser is a system designed for the purple day. Welcome to our website.
Comments
Post a Comment